HRRSDental DENTEX DENCOVER Light Cure Liquid Polish

whatsapp ‪+8613056145518‬

DENCOVER (LIGHT CURE LIQUID POLISH)
GENERAL INFORMATION AND INSTRUCTION FOR USE
DENCOVER is a low-viscosity, light-cured resin formulation used to seal the surface of restorations while leaving a smooth polished/glazed surface.

Due to its unique proprietary chemistry, DENCOVER cures without any sticky oxygen-inhibited layer.

DENCOVER may reduce or even eliminate the need for manual polishing.

The unique chemistry of DENCOVER allows for the use of LED and halogen curing lights to achieve polymerization.

PACKAGES:
Refill: 3.0ml /bottle

INDICATIONS FOR USE:
DENCOVER is used to seal and polish/glaze:
A. Newly placed direct composites (cured only)
B. Previously placed direct composites
C. Indirect composites
Provisionals
D. Resin-modified glass ionomers
E. Enamel before or after orthodontic bracket placement
F. Enamel after whitening (bleaching)

Applying DENCOVER:
1. Dispense DENCOVER into a mixing well. Dip the brush into the DENCOVER.

Wipe excess from the brush onto the side of mixing well.

The brush does not need to be saturated, just wet enough to apply one thin coat.

2.Apply one thin coat of DENCOVER in one direction with a smooth stroke.

Do not agitate the brush during application. It is very important that one allows 15 seconds dwelling time for evaporation of solvent after application.

Do not air thin as this will disperse the material unevenly causing ripples on the surface.

3. DENCOVER uses the following curing lights and curing times to initiate polymerization.Insufficient curing will leave an air-inhibited layer on the surface of DENCOVER.

a. LED Lights: Light cure for 30 seconds at close range (0-2mm).

b. Halogen Lights: Using a halogen curing unit, light cure for 30 seconds at close range (0-2mm).

c. PAC (Plasma Arc) Lights: Using a PAC light, light cure for 10 seconds at close range (0-2mm).

4. If a second coat is desired, repeat steps 1-3.

WARNING:
1. Avoid splashing into the eyes. If DENCOVER comes into contact with the eyes, flush with copious amounts of water and seek medical attention

2. Upon curing, DENCOVER may produce a brief exothermic reaction which is minimized by applying in a thin layer. Do not cure on soft tissue.

3. The phosphoric acid in the etchant is a severe eye and skin irritant. Injury may result if the etchant is allowed to remain on the skin or mucosa for extended periods of time. If accidentally splashed into the eye, flush with copious amounts of water and seek medical attention immediately. In case of contact with other tissues, rinse immediately with plenty of water for several minutes.

4. A rubber dam is recommended for all restorations and other indications where contamination may be possible.

STORAGE: Store at 25℃ or less in a cool and dry place and avoid direct sun exposure. Recap the bottle after use.

DISPOSAL: After the product is used up, disposal it as normal medical rubbish.

SHELF LIFE: 3 years